Assembly and Installation Instructions
Invert rocking chair on a solid surface with padding between surface and the rocking chair. Fit the rocking chair runners onto the tenons at the bottom of the rocker legs. The front of the rocker runner has the tenon hole closest to the end of the rocker runner. Using little force, tap the rocker runner front FIRST and then the back. Repeat front to back until you have a good fit. When the tenon is halfway into the holes in the rocker runner you can use force to get the runners all the way on. Hammer the rocker runners until the tenons are fitted down into the rocking chair runner. Since the runners are made of oak force will not hurt them. After the runners are fitted properly into all of the rocking chair legs use the stainless steel nails provided to attach the runners to the tenons. Turn the rocking chair on its side and hammer the nails from the inside of the rocker runners into the tenon. Pre-drilling the holes may ease runner attachment. PLEASE USE CAUTION WHEN NAILING ONTO PAINTED SURFACES. USE OF SAFETY GLASSES IS RECOMMENDED. PLEASE CALL IF YOU NEED ADDITIONAL ASSISTANCE.